Push-in fitting, bulkhead design, bulkhead thread M 17x1, tube 8 mm, PVDF

The material is PVDF, the size is fixed at tube diameter 8 mm. The push-in fitting connects the bulkhead thread M 17x1 and a tube of 8 mm outside diameter in doing so. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 8 is clearly assigned and stays available for reordering
• The connection over bulkhead thread M 17x1 is fixed in size and needs no adaptor
• With tube diameter 8 mm the size is fixed, so no reworking of the line is required
• The bulkhead panel may be up to 16 mm thick

Technical data

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.