Push-in fitting, bulkhead design, thread M 16x1, tube 8 mm, nickel plated brass, -20 bis +80 °C

The push-in fitting brings the bulkhead thread M 16x1 and a tube of 8 mm outside diameter together. The temperature range reaches from -20 °C to +80 °C. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The temperature range from -20 °C to +80 °C covers cold installation and warm machine surroundings
• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• The bulkhead panel may be up to 16 mm thick
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.