Push-in fitting, bulkhead design, bulkhead thread M 16x1, tube 8 mm, stainless steel 1.4404

The push-in fitting accepts the bulkhead thread M 16x1 and a tube of 8 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 15 bar. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C
• The bulkhead panel may be up to 17 mm thick
• Approvals to FDA are documented for the materials

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.