Push-in fitting, bulkhead design, thread M 14x1, tube 6 mm, nickel plated brass, -20 bis +80 °C

The temperature range reaches from -20 °C to +80 °C. The push-in fitting connects the bulkhead thread M 14x1 and a tube of 6 mm outside diameter in doing so. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The bulkhead panel may be up to 11 mm thick
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over bulkhead thread M 14x1 is fixed in size and needs no adaptor

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.