Push-in fitting, bulkhead design, bulkhead thread M 12x1, tube 4 mm, PVDF

This push-in fitting is designed for the bulkhead thread M 12x1 and a tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is PVDF, the size is fixed at tube diameter 4 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• The bulkhead panel may be up to 13 mm thick
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.