Push-in fitting, bulkhead design, bulkhead thread M 12x1, tube 4 mm, stainless steel 1.4404

The push-in fitting brings the bulkhead thread M 12x1 and a tube of 4 mm outside diameter together. The operating pressure reaches from -0.95 bar to 15 bar. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The operating pressure from -0.95 bar to 15 bar is released for this size
• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C
• The bulkhead panel may be up to 11 mm thick
• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -20 °C to +150 °C

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.