Push-in fitting, bulkhead design, bulkhead thread M 24x1, tube 12 mm, polypropylene, FDA compliant

This push-in fitting joins the bulkhead thread M 24x1 and a tube of 12 mm outside diameter in one part. The material is polypropylene, FDA compliant, the size is fixed at tube diameter 12 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The connection over bulkhead thread M 24x1 is fixed in size and needs no adaptor
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The bulkhead panel may be up to 15 mm thick
• The design stainless steel is clearly designated in the data sheet
• Approvals to FDA are documented for the materials

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA.