Push-in fitting, bulkhead design, bulkhead thread M 24x1, tube 12 mm, stainless steel

This push-in fitting joins the bulkhead thread M 24x1 and a tube of 12 mm outside diameter in one part. The material is stainless steel, the size is fixed at tube diameter 12 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The size 12 is clearly assigned and stays available for reordering
• The connection over bulkhead thread M 24x1 is fixed in size and needs no adaptor
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The bulkhead panel may be up to 13 mm thick
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.