Hose tail, thread G 2", 50x68 mm, 1.4301, for hose connection

For water, compressed air and other technical media the hose tail provides the hose connection. 1.4301 determines the load capacity and the corrosion behaviour. The joint is created via the thread G 2". The hose diameter is 50x68 mm.

Benefits

• The transition from thread to hose takes place in 1 component without an additional adapter.
• The version is defined according to DIN EN 14423.
• The thread G 2" fits the existing port without an adapter.
• At 50x68 mm the hose diameter is defined in the data sheet and can be planned in advance.
• The barbs hold the hose after it has been pushed on, 1 hose clamp is enough to secure it.

Applications

Hose connection to pipework, connection of pumps and tools, water and compressed air lines. The selection follows the existing port and the operating load of the system.

Standards and conformity

The following standards are documented for this component: DIN EN 14423.