45 degree press fitting bend, pipe 15 mm, stainless steel 1.4404

This 45 degree press fitting bend joins a pipe of 15 mm outside diameter and the continuing line in one part. The material is stainless steel 1.4404. The 45 degree design continues the line at an angle and avoids tight bends.

Benefits

• With pipe diameter 15 mm the size is fixed, so no reworking of the line is required
• The change of direction by 45 degrees saves installation length ahead of the port
• The installation dimensions a of 37 mm and z of 11 mm are stated
• The press joint is made in a single operation without an open flame
• The size 15 is clearly assigned and stays available for reordering

Applications

Compressed air networks in workshop and hall, water and cooling circuits, cooling and heating water lines, thermal solar systems with glycol mixture.

Standards and conformity

Pressing is done with jaws of the SA, M and V press profiles.