45 degree press fitting bend, tube 15 mm, nipple 15 mm, copper and copper alloy

The 45 degree press fitting bend accepts a tube of 15 mm outside diameter and a nipple of 15 mm diameter. The part is pressed permanently with the jaw in a single operation. The material is copper and copper alloy. The 45 degree design continues the line at an angle and avoids tight bends.

Benefits

• The press joint is made in a single operation without an open flame
• The size 15 is clearly assigned and stays available for reordering
• With tube diameter 15 mm the size is fixed, so no reworking of the line is required
• The change of direction by 45 degrees saves installation length ahead of the port

Technical data

Applications

Thermal solar systems with glycol mixture, refurbishment of existing pipe networks, compressed air networks in workshop and hall, water and cooling circuits.

Standards and conformity

The fitting is intended for commercial copper tube to EN 1057. Pressing is done with jaws of the SA, M and V press profiles.