Push-in fitting, elbow design, thread R 1/8", tube 6 mm, polypropylene, FDA compliant, -20 to +80 °C

The material is polypropylene, FDA compliant, the size is fixed at tube diameter 6 mm. The push-in fitting connects the male thread R 1/8" and a tube of 6 mm outside diameter in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• Approvals to FDA are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The connection over male thread R 1/8" is fixed in size and needs no adaptor
• With tube diameter 6 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA.