Push-in fitting, elbow design, male thread NPT 1/4", tube 6 mm, stainless steel

The push-in fitting accepts the male thread NPT 1/4" and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 18 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The temperature range from -15 °C to +110 °C covers cold installation and warm machine surroundings
• The material stainless steel stays resistant without additional coating in the range from -15 °C to +110 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The seal in NBR is matched to the range from -15 °C to +110 °C

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.