Push-in fitting, elbow design, large design, male thread G 1", tube 28 mm, brass and POM

This push-in fitting is designed for the male thread G 1" and a tube of 28 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is brass and POM, the size is fixed at tube diameter 28 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With tube diameter 28 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 28 is clearly assigned and stays available for reordering

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.