Push-in fitting, elbow design, thread G 1/8", tube 6 mm, nickel plated brass

The temperature range reaches from -20 °C to +150 °C. The push-in fitting connects the male thread G 1/8" and a tube of 6 mm outside diameter in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The change of direction by 90 degrees saves installation length ahead of the port
• The design high temperature is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over male thread G 1/8" is fixed in size and needs no adaptor

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.