Push-in fitting, elbow design, thread G 1/4", tube 4 mm, polypropylene, FDA compliant

This push-in fitting is designed for the male thread G 1/4" and a tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is polypropylene, FDA compliant. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to FDA are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA.