Push-in fitting, elbow design, large design, male thread G 1/2", tube 18 mm, POM, seal NBR

This push-in fitting joins the male thread G 1/2" and a tube of 18 mm outside diameter in one part. The material is POM, the size is fixed at tube diameter 18 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The size 18 is clearly assigned and stays available for reordering
• The connection over male thread G 1/2" is fixed in size and needs no adaptor
• With tube diameter 18 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.