Cutting ring fitting, elbow design, thread M 10x1 (konisch), tube 8 LL (M12x1), zinc plated steel

The cutting ring fitting brings the male thread M 10x1 (konisch) and a tube 8 LL (M12x1) together. The operating pressure reaches up to 100 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The operating pressure up to 100 bar is released for this size
• The temperature range from -40 °C to +120 °C covers cold installation and warm machine surroundings
• Zinc plated steel carries the load of the joint in the range from -40 °C to +120 °C
• The very light series with the code LL follows the dimension series to ISO 8434-1
• The change of direction by 90 degrees saves installation length ahead of the port
• The cutting ring bites into the tube wall and holds the tube even under pressure surges

Applications

Repair of existing tube fittings, test benches and power unit construction, hydraulic lines in machine and plant engineering, pipework on presses and pumps.

Standards and conformity

The tube fitting follows the design of cutting ring tube fittings to ISO 8434-1, formerly DIN 2353.