Plastic pipe - Riegler K207

Plastic pipe. This range covers 7 variants from 46.95 EUR. Select the version you need above.

Available variants

Shared technical data

About Pipes and coils

Tubing and coil stock form the fixed distribution level between the compressor and the consumer, with connectors only at the ends. Outside diameters run from 4 to 54 mm and permitted working pressures from 6 to 38 bar, reaching down to -0.95 bar under vacuum. Delivery is either on coils or as straight lengths.

What matters when choosing

• Material comes first. Hard PA 12 to DIN 73378 suits control and machine lines, LLDPE and LDPE are supplied as coil stock, and surface-coated aluminium is used for fixed distribution piping.
• Tube outside diameter from 4 to 54 mm has to match the push-in connector. The speedfit and sharkbite series are dimensioned for it.
• Maximum working pressure lies between 6 and 38 bar depending on material and wall thickness. Use the figure of the actual tube rather than the top value of the group.
• Operating temperature reaches down to -60 °C on the cold-rated versions and up to 65 °C or 100 °C at the upper end.
• Delivery form and installation belong together. Coil length, tube length and the minimum bending radius decide how many bends and connectors a run needs.

Typical applications

• Compressed air ring mains in workshops and production halls.
• Machine and cylinder plumbing with PA 12.
• Cold water and drinking water lines in LLDPE or LDPE.
• Drop lines to service units and take-off points.
• Vacuum lines down to -0.95 bar.

LLDPE and LDPE tubing carries approvals to DVGW worksheet W270, KTW, NSF and WRAS and is suitable for cold water with a chlorine content of up to 4 ppm. Aluminium tubing is corrosion-resistant and electrically insulating, and the 46 articles in this group come from Germany, the United Kingdom, Italy and Turkey.