High pressure tee fitting, thread G 1-1/4", PN 160 bar, zinc plated steel

For measuring points, secondary runs and return lines the high pressure tee fitting forms the branching point. The material used is zinc plated steel. The thread G 1-1/4" accepts the mating part. The nominal pressure is 160 bar.

Benefits

• 3 ports in one component replace two separate fittings and an intermediate line.
• The branch sits at 90° to the through axis and keeps the flow deflection short.
• Steel takes the tightening torque on the G 1-1/4" thread without permanent deformation.
• The nominal pressure of 160 bar defines the load limit of the joint.

Applications

Branches and measuring points, distribution to secondary runs, return lines. The zinc plated steel suits hydraulic and compressed air lines in mechanical engineering.