Thread extension, male thread G 1/4", length 18 mm, PN 16 bar, brass, width across flats 17 mm

The thread extension joins two line ends of the same or of different thread size into one tight run. Brass determines the load capacity and the corrosion behaviour. The joint is created via the male thread G 1/4". The nominal pressure is stated as 16 bar.

Benefits

• Both sides carry a thread, so 1 component replaces two separate transition pieces.
• The bore runs through and does not narrow the cross section at either of the 2 connection sides.
• Brass does not form any scale and stays free moving on the G 1/4" thread even after years.
• The nominal pressure of 16 bar defines the load limit of the joint.
• The male thread G 1/4" fits the existing port without an adapter.
• At 18 mm the overall length is defined in the data sheet and can be planned in advance.

Technical data

Applications

Pipework construction, extension of existing runs, connection of valves. Brass is used in device engineering, in workshops and in water installation.