Set screw with hexagon socket and cup point DIN 916 / ISO 4029, M 6x30, stainless steel A2

In use, the set screw with cup point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the cup point at its end. It is produced from stainless steel A2. The data give thread M 6 and length 30 mm.

Benefits

• Thread M 6 at a length of 30 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 3 mm, so the screw can be tightened recessed and with a repeatable torque.
• The cup point bites into the surface of the shaft and holds even where no hole and no flat have been prepared.
• Made of stainless steel A2 to DIN 916.

Applications

In jigs made of stainless steel A2 the screw holds a workpiece without slipping because the cup point bites into the surface.

Standards and conformity

The 3 mm hexagon socket follows the standard, so no special tool is needed.