Set screw with hexagon socket and cup point DIN 916 / ISO 4029, M 6x20, stainless steel A2

Made to DIN 916, this set screw with cup point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the cup point at its end. In addition the sheet lists a length of 20 mm. This version comes with thread M 6 and length 20 mm.

Benefits

• Thread M 6 at a length of 20 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 3 mm, so the screw can be tightened recessed and with a repeatable torque.
• The cup point bites into the surface of the shaft and holds even where no hole and no flat have been prepared.
• Made of stainless steel A2 to DIN 916.

Applications

On a shaft collar on a plain shaft the M 6x20 set screw holds the hub through its cup point alone.

Standards and conformity

The 3 mm hexagon socket follows the standard, so no special tool is needed.