Set screw with hexagon socket and cup point DIN 916 / ISO 4029, M 10x25, stainless steel A2

The set screw with cup point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the cup point at its end and follows DIN 916. The data state a hexagon socket of 5 mm. This version is listed with thread M 10 and length 25 mm. Material stainless steel A2 is listed for this version.

Benefits

• Thread M 10 at a length of 25 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 5 mm, so the screw can be tightened recessed and with a repeatable torque.
• The cup point bites into the surface of the shaft and holds even where no hole and no flat have been prepared.
• Made of stainless steel A2 to DIN 916.

Applications

In jigs made of stainless steel A2 the screw holds a workpiece without slipping because the cup point bites into the surface.

Standards and conformity

Dimensions and design follow DIN 916, thread M 10 is a metric coarse thread.