Set screw with hexagon socket and cup point DIN 916 / ISO 4029, M 10x10, steel 45 H

Made to DIN 916, this set screw with cup point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the cup point at its end. This version is listed with thread M 10 and length 10 mm. The stated figure is a hexagon socket of 5 mm.

Benefits

• Thread M 10 at a length of 10 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 5 mm, so the screw can be tightened recessed and with a repeatable torque.
• The cup point bites into the surface of the shaft and holds even where no hole and no flat have been prepared.
• Made of steel 45 H to DIN 916.

Applications

When securing a gear or a pulley no hole in the shaft is needed, the cup point bites into the surface.

Standards and conformity

The 5 mm hexagon socket follows the standard, so no special tool is needed.