Set screw with hexagon socket and dog point DIN 915 / ISO 4028, M 8x8, steel 45 H

The set screw with dog point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the dog point at its end. In addition the sheet lists a length of 8 mm. This version comes with thread M 8 and length 8 mm.

Benefits

• Thread M 8 at a length of 8 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 4 mm, so the screw can be tightened recessed and with a repeatable torque.
• The dog point engages in a hole or groove in the shaft and secures the hub against turning by form fit.
• Made of steel 45 H to DIN 915.

Applications

On a lever or handwheel the dog point engages in the hole in the shaft, so the position is unambiguous.

Standards and conformity

The 4 mm hexagon socket follows the standard, so no special tool is needed.