Set screw with hexagon socket and dog point DIN 915 / ISO 4028, M 4x8, stainless steel A2

Once installed, the set screw with dog point secures a hub, a shaft collar or a lever on the shaft and transmits the torque through the dog point at its end. This version is listed with thread M 4 and length 8 mm. The stated figure is a hexagon socket of 2 mm.

Benefits

• Thread M 4 at a length of 8 mm, so the screw sits fully inside the thread and does not stand out beyond the hub.
• Hexagon socket 2 mm, so the screw can be tightened recessed and with a repeatable torque.
• The dog point engages in a hole or groove in the shaft and secures the hub against turning by form fit.
• Made of stainless steel A2 to DIN 915.

Technical data

Applications

On a lever or handwheel the dog point engages in the hole in the shaft, so the position is unambiguous.

Standards and conformity

The 2 mm hexagon socket follows the standard, so no special tool is needed.