Push-in fitting, straight design, male thread R 1/4", tube 8 mm, stainless steel 1.4404

This push-in fitting joins the male thread R 1/4" and a tube of 8 mm outside diameter in one part. The operating pressure reaches from -0.95 bar to 15 bar. The straight design carries the medium through the part without deflection.

Benefits

• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over male thread R 1/4" is fixed in size and needs no adaptor
• With tube diameter 8 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 15 bar is released for this size

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.