Push-in fitting, straight design, male thread NPT 3/8", tube 10 mm, stainless steel 1.4404

The push-in fitting accepts the male thread NPT 3/8" and a tube of 10 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 15 bar. The straight design carries the medium through the part without deflection.

Benefits

• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C
• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -20 °C to +150 °C

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.