Push-in fitting, straight design, large design, male thread G 1/2", tube 18 mm, POM

This push-in fitting is designed for the male thread G 1/2" and a tube of 18 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is POM. The straight design carries the medium through the part without deflection.

Benefits

• With tube diameter 18 mm the size is fixed, so no reworking of the line is required
• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 18 is clearly assigned and stays available for reordering
• The connection over male thread G 1/2" is fixed in size and needs no adaptor

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.