Push-in fitting, straight design, tube 8 mm, second port 8 mm, stainless steel 1.4404

This push-in fitting joins a tube of 8 mm outside diameter and a second tube of 8 mm outside diameter in one part. The operating pressure reaches from -0.95 bar to 15 bar. The straight design carries the medium through the part without deflection.

Benefits

• The seal in FKM is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 8 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 15 bar is released for this size
• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.