Push-in fitting, straight design, tube 4 mm, second port 4 mm, PVDF

This push-in fitting is designed for a tube of 4 mm outside diameter and a second tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is PVDF, the size is fixed at tube diameter 4 mm. The straight design carries the medium through the part without deflection.

Benefits

• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.