Push-in fitting, straight design, large design, tube 32 mm, second port 32 mm, polypropylene

The push-in fitting accepts a tube of 32 mm outside diameter and a second tube of 32 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is polypropylene. The straight design carries the medium through the part without deflection.

Benefits

• The size 32 is clearly assigned and stays available for reordering
• With tube diameter 32 mm the size is fixed, so no reworking of the line is required
• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.