Push-in fitting, straight design, tube 16 mm, second port 16 mm, stainless steel 1.4404

The push-in fitting brings a tube of 16 mm outside diameter and a second tube of 16 mm outside diameter together. The operating pressure reaches from -0.95 bar to 10 bar. The straight design carries the medium through the part without deflection.

Benefits

• The temperature range from -15 °C to +120 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -15 °C to +120 °C
• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -15 °C to +120 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 16 mm the size is fixed, so no reworking of the line is required

Technical data

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.