Push-in fitting, straight design, high temperature version, tube 16 mm, nickel plated brass

The push-in fitting accepts a tube of 16 mm outside diameter and a second tube of 16 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The temperature range reaches from -20 °C to +150 °C. The straight design carries the medium through the part without deflection.

Benefits

• The design high temperature is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 16 mm the size is fixed, so no reworking of the line is required

Technical data

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.