Push-in fitting, straight design, tube 10 mm, second port 8 mm, PVDF

The material is PVDF, the size is fixed at tube diameter 10 mm. The push-in fitting connects a tube of 10 mm outside diameter and a second tube of 8 mm outside diameter in doing so. The straight design carries the medium through the part without deflection.

Benefits

• The size 10 is clearly assigned and stays available for reordering
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• The transition from 10 mm to 8 mm saves an additional reducer
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.