Straight reducing supports - Riegler K1120

Straight reducing supports. This range covers 3 variants from 1.03 EUR. Select the version you need above.

Available variants

Shared technical data

About Hose connectors

Straight connectors join two hose ends in line, and as reducing versions they also bridge two different bores. The group covers hose I.D. 2 to 25 mm at a maximum working pressure of 10 bar. The barb is pushed into the hose and held with a clamp, so no thread is involved.

What matters when choosing

• Hose I.D. of 2 to 25 mm is the governing dimension and the axis of the configurators. It has to match the bore of the hose already installed.
• Same size or reducing: the reducing versions carry two figures, hose I.D. 1 and hose I.D. 2, and make the step between two hose bores in a single part.
• Material acetal copolymer (POM) or brass CW617N. POM is light, abrasion-resistant and impact-tough, while the brass parts are intended for PA and PUR hose.
• Max. working pressure of 10 bar applies to the whole group. Anything above that belongs on a screwed union rather than a barb and clamp.
• Min. and max. temperature: the POM versions are rated -40 to 80 °C. Cold outdoor locations and warm process air still fit, hot media do not.

Typical applications

• Extending compressed air hoses at machines and assembly stations
• Stepping between two hose bores in pilot lines
• Repairing damaged PA and PUR lines
• Low-pressure coolant and flushing lines
• Temporary routing on test and trial rigs

The materials used are acetal copolymer (POM) and brass CW617N. Manufacturing takes place in Germany and China.