Carriage bolt DIN 603 with square neck, M 10x90, stainless steel A2 (without nut)

This carriage bolt to DIN 603 joins two parts with a flat head that hardly protrudes and locks itself against turning through the square neck. This version comes with thread M 10 and length 90 mm. A further figure is a head height of 5.0 mm.

Benefits

• Thread M 10 at a length of 90 mm, the thread length is 26 mm.
• Flat head 24 mm across and only 5.0 mm high, so the bearing area stays large and the head hardly protrudes.
• Square 10 mm under the head, it engages in the hole and holds the bolt while it is tightened.
• The matching hexagon nut has a width across flats of 17 mm to DIN and 16 mm to ISO 8677.
• Made of stainless steel A2 (without nut) to DIN 603.

Applications

On a joint that is accessible from one side only, the 10 mm square holds the bolt while the nut is tightened.

Standards and conformity

Dimensions and design follow DIN 603, the matching hexagon nut complies with ISO 8677.