Collar drill bushing form A to DIN 172, bore 35 x 45 mm, collar 52 mm, case-hardening steel

Made for holes of 35 mm, this bushing guides the tool over 45 mm. The medium series combines a press fit of 48 mm outside diameter with a 52 mm collar that holds the bushing in the plate.

Benefits

• Ground guiding bore of 35 mm within the tolerances of DIN 172
• Press fit of 48 mm outside diameter in the holder of the jig
• All-round collar of 52 mm diameter and 5.0 mm height acting as a stop
• Guiding length of 45 mm, medium design
• Form A design of DIN 172 with the bore rounded on one side, on the side of the collar
• Hardened case-hardening steel at 740 ± 80 HV 10 with a ground surface

Technical data

Applications

It is typically fitted into the drill plates of jigs in mechanical engineering, contract manufacturing and mould making, where the same 35 mm hole is produced again and again in the same place.

Standard and material

The basis is DIN 172, form A, with a guiding bore of 35 mm. In form A the bore is rounded only on the side of the collar. The material is case-hardening steel, hardened to 740 ± 80 HV 10 and ground afterwards.