Collar drill bushing DIN 172 form A, bore 23 mm, length 45 mm, collar 39 mm, hardened steel

Made for holes of 23 mm, this bushing guides the tool over 45 mm. The long series combines a press fit of 35 mm outside diameter with a 39 mm collar that holds the bushing in the plate.

Benefits

• Bore 23 mm, ground and dimensionally accurate to DIN 172
• Outside diameter 35 mm for the press fit in the drill plate
• Collar 39 mm with 5.0 mm height for axial location
• Overall length 45 mm in the long series
• Form A to DIN 172, the bore is rounded on the collar side so the tool enters easily
• Case-hardening steel, hardened to 740 ± 80 HV 10 and ground

Technical data

Applications

It is typically fitted into the drill plates of jigs in mechanical engineering, contract manufacturing and mould making, where the same 23 mm hole is produced again and again in the same place.

Standard and material

The basis is DIN 172, form A, with a guiding bore of 23 mm. In form A the bore is rounded only on the side of the collar. The material is case-hardening steel, hardened to 740 ± 80 HV 10 and ground afterwards.