Collar drill bushing DIN 172 form A, bore 14.7 mm, length 16 mm, collar 26 mm, hardened steel

This bushing of the short series guides drills of 14.7 mm diameter over 16 mm. The collar with 4.0 mm height stops the bushing from being pushed down through the holder during machining and sets its height clearly.

Benefits

• Ground guiding bore of 14.7 mm within the tolerances of DIN 172
• All-round collar of 26 mm diameter and 4.0 mm height acting as a stop
• Press fit of 22 mm outside diameter in the holder of the jig
• Hardened case-hardening steel at 740 ± 80 HV 10 with a ground surface
• Guiding length of 16 mm, short design
• Form A design of DIN 172 with the bore rounded on one side, on the side of the collar

Applications

It is used wherever holes of 14.7 mm have to be produced without centre punching and without wandering, for example in jigs for series parts, in assembly gauges or in prototype work.

Standard and material

The basis is DIN 172, form A, with a guiding bore of 14.7 mm. In form A the bore is rounded only on the side of the collar. The material is case-hardening steel, hardened to 740 ± 80 HV 10 and ground afterwards.