Pressure Relief Valve DBGT-2X/700VP2 - Bosch Rexroth R901358101

Rather than a hand adjustment, a DC motor takes over the setpoint: pressure follows the electrical signal, up to 315 bar operating pressure at 600 l/min flow. The DBGT series is built in the 700 bar pressure rating, working as a proportional pressure valve in poppet seat design.

Benefits

• Electrical pressure setting through a DC motor, no adjusting screw on the valve
• Flow up to 600 l/min at a maximum operating pressure of 315 bar
• Poppet seat design with pilot stage, 2 ports in 2 switching positions
• FKM seals for HL fluid, mass of 7.4 kg
• Wired through a mating connector, 6-pole (5 + PE) according to EN 43651, external electronics on 24 VDC

Applications

The valve is used where several pressure levels run within one cycle, in presses, test rigs as well as clamping systems. Motor drive holds the set value even under vibration. Control edges run from A to B as well as from X to Y.

Manufacturer

Bosch Rexroth lists this valve under material number R901358101. Curves plus notes on the control electronics are documented for the DBGT series.