Pumpenregelsystem SYDFEE-2X/028R-PRA12KC1-0000-A0A0VX1 - Bosch Rexroth R901041424

Pressure and flow of a hydraulic power unit are set electrically here, without a separate control amplifier in the cabinet. The variable pump with 28 cm3 displacement reaches 84 l/min maximum flow at up to 280 bar operating pressure, and the on-board electronics close the loop on swivel angle and pressure from an analog command value.

Benefits

• Swivel angle control and pressure control sit in the pump itself, driven by an analog signal through a connector, 12-pole (11 + PE) according to EN 175201-804.
• Master and slave operation allows several pumps to follow one shared command value.
• 84 l/min maximum flow and 280 bar maximum operating pressure from 28 cm3 displacement.
• Through-drive fitted, so a second pump can be mounted on the same drive shaft.
• Geared shaft (R) and ISO 2-hole mounting flange, clockwise direction of rotation, 25.3 kg weight.
• Component series 2X with a 200 bar preload valve, 24 V DC supply, FKM seals for hydraulic fluid HLP.

Technical data

Applications

The system is used in power units for presses, test rigs, plastics machinery and special purpose machines whose pressure and flow are commanded from the controller. Because the pump only swivels to the requested angle, surplus oil does not have to be dumped continuously across a pressure relief valve. Mounting is by the ISO 2-hole flange with a geared shaft (R) in clockwise rotation, and the through-drive stays free for a further pump. Hydraulic fluid HLP and FKM seals are specified for this system.

Manufacturer

Bosch Rexroth lists the pump control system under material number R901041424. Curves, dimensions and connector pin assignment are given in data sheet RD 30030.