Drill bush DIN 179 form A, long type, bore 17.5 mm, length 36 mm, outside dia 26 mm

A drill of 17.5 mm diameter runs guided through 36 mm of this bush and meets the hole at the intended point. The design follows DIN 179, form A, and the bore is rounded on one side.

Benefits

• Guide bore of 17.5 mm to DIN 179 for the matching tool
• Outside diameter of 26 mm as a ground seat in the drill plate
• Overall length of 36 mm in the long version of the range short, medium and long
• Special case-hardening steel, hardened to 740 ± 80 HV 10 and ground
• Bore rounded on one side to form A, with a fixed fitting direction in the jig

Applications

• Hole patterns in assembly jigs and equipment frames
• Workshop production with changing workpieces
• Redrilling and opening up holes on existing jigs
• Pattern making and mould making

Standard and material

The bush is made to DIN 179 in form A, and the bore is rounded on one side. The material is special case-hardening steel, hardened to 740 ± 80 HV 10 and ground.