Weld-on socket, half overall length, thread Rp 2-1/2", 30 mm, D 82.0 mm, steel ST 37-2

The weld-on socket joins two line ends of the same or of different thread size into one tight run. Steel ST 37-2 determines the load capacity and the corrosion behaviour. The joint is created via the thread Rp 2-1/2". The overall length comes to 30 mm.

Benefits

• The version is defined according to DIN 2986.
• Steel takes the tightening torque on the Rp 2-1/2" thread without permanent deformation.
• The thread Rp 2-1/2" fits the existing port without an adapter.
• At 30 mm the overall length is defined in the data sheet and can be planned in advance.
• Both sides carry a thread, so 1 component replaces two separate transition pieces.
• The bore runs through and does not narrow the cross section at either of the 2 connection sides.

Technical data

Applications

Pipework construction, extension of existing runs, connection of valves. The zinc plated steel suits hydraulic and compressed air lines in mechanical engineering.

Standards and conformity

The following standards are documented for this component: DIN 2986.