Weld-on socket, half overall length, thread Rp 1/8", 8 mm, D 15.0 mm, steel ST 37-2

Where a pipe run has to be extended or led onto another thread, the weld-on socket takes over the connection. Steel ST 37-2 determines the load capacity and the corrosion behaviour. The joint is created via the thread Rp 1/8". The overall length is 8 mm.

Benefits

• The thread Rp 1/8" fits the existing port without an adapter.
• At 8 mm the overall length is defined in the data sheet and can be planned in advance.
• Both sides carry a thread, so 1 component replaces two separate transition pieces.
• The bore runs through and does not narrow the cross section at either of the 2 connection sides.
• The version is defined according to DIN 2986.

Technical data

Applications

Pipework construction, extension of existing runs, connection of valves. The zinc plated steel suits hydraulic and compressed air lines in mechanical engineering.

Standards and conformity

The following standards are documented for this component: DIN 2986.