Parallel gripper with ball guide, double-acting, 20 mm bore, 9.8 mm jaw travel - E.MC

The double-acting parallel gripper drives both fingers open and closed with compressed air, so it grips shafts and pins from the outside as well as bores from the inside. With a 20 mm bore each finger holds 45 N closing and 68 N opening, measured at 0.5 MPa and 20 mm gripping point distance.

Advantages

• Permissible vertical load 147 N on the fingers
• Up to 180 cycles per minute, no lubrication required
• Magnetic piston as standard, mounting at the rear, front with thread or through hole, and at the side
• Ball guide, fingers and guide in hardened stainless steel, repeatability ±0.01 mm

Applications

• Precise insertion of small parts in assembly fixtures
• External gripping of shafts, pins and turned parts
• Internal gripping in bores and sleeves with the same gripper

Accessories and spare parts

The repair kit for the parallel gripper with 20 mm bore is available separately and fits the double-acting as well as both single-acting versions of this size.