Parallel gripper with ball guide, double-acting, 10 mm bore, 3.4 mm jaw travel - E.MC

The double-acting parallel gripper drives both fingers open and closed with compressed air, so it grips shafts and pins from the outside as well as bores from the inside. With a 10 mm bore each finger holds 11 N closing and 17 N opening, measured at 0.5 MPa and 20 mm gripping point distance.

Advantages

• Magnetic piston as standard, mounting at the rear, front with thread or through hole, and at the side
• Ball guide, fingers and guide in hardened stainless steel, repeatability ±0.01 mm
• 11 N closing and 17 N opening per finger at 0.5 MPa
• Permissible vertical load 58 N on the fingers

Applications

• External gripping of shafts, pins and turned parts
• Internal gripping in bores and sleeves with the same gripper
• Precise insertion of small parts in assembly fixtures

Accessories and spare parts

The repair kit for the parallel gripper with 10 mm bore is available separately and fits the double-acting as well as both single-acting versions of this size.