IO-Link fieldbus valve terminal, 16 x 5/2-way single solenoid, M7 top ports on the valves, 24 V DC - E.MC

This E.MC S1V series valve terminal combines 16 single-solenoid 5/2-way valves on a common base plate. Supply and exhaust run centrally through G 1/8, while the M7 working ports are located on top of the valves. A IO-Link bus module comes fitted, so the controller addresses every solenoid over the network. Overall length is 256.5 mm.

Advantages

• IO-Link bus module with M12, A-coded, port class B, module current draw below 25 mA.
• Response time of 15 ms or less at 5 bar and up to 5 switching cycles per second per valve.
• Only 0.8 W per solenoid at 24 V DC ±10 %, so 16 valves draw 12.8 W in total.
• Diagnostics report communication faults, short circuit, wire break, reverse polarity and under- or overvoltage, and the output state on bus failure can be parameterised.
• M7 ports with a nominal cross-section of 7 mm² (Cv 0.39), around 330 l/min flow per station.

Applications

• Decentralised valve group on an IO-Link master, connected by a single M12 cable to a class B port.
• Medium-bore cylinders that move briskly with 330 l/min per station.
• Packaging and feeding systems in which 16 actuators are switched from one central manifold.
• Cabinet or machine mounting with easily accessible tube connections on top of each valve.

Conversion and extension

The valves can be swapped for individually available valves with one or two solenoids or for blanking plates. Stations are counted from the electrical connection.