Push-in fitting, 45 degree design, miniature design, thread R 1/8", tube 4 mm, nickel plated brass

This push-in fitting joins the male thread R 1/8" and a tube of 4 mm outside diameter in one part. The material is nickel plated brass, the size is fixed at tube diameter 4 mm. The 45 degree design continues the line at an angle and avoids tight bends.

Benefits

• The connection over male thread R 1/8" is fixed in size and needs no adaptor
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• The change of direction by 45 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.